astra_conv:conversion:wiring:wiring
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
astra_conv:conversion:wiring:wiring [2014/03/07 17:11] richard [logics] |
astra_conv:conversion:wiring:wiring [2014/03/07 17:27] richard |
||
|---|---|---|---|
| Line 141: | Line 141: | ||
| As another example, the "HV isolation check failed" alarm generated by the HV isolation check board actually provides one "ground contact" and one "active 12V" output. The ground contact output goes to the immobilizer latch (which avoids that the immobilizer is triggered during driving), while the "active 12V" output again is fed to the HV alarm unit of the BMS peripherals board. | As another example, the "HV isolation check failed" alarm generated by the HV isolation check board actually provides one "ground contact" and one "active 12V" output. The ground contact output goes to the immobilizer latch (which avoids that the immobilizer is triggered during driving), while the "active 12V" output again is fed to the HV alarm unit of the BMS peripherals board. | ||
| - | {{:astra_conv:conversion:wiring:alarms_overview02.jpg?950|}} | + | {{:astra_conv:conversion:wiring:alarms_overview03.jpg?1000|}} |
| + | |||
| + | {{:astra_conv:conversion:wiring:alarms_overview03.jpg?linkonly|link to alarms table (jpg), right-click and save as file (or directly open with a picture viewer)}} | ||
| {{actionlink>top|*** back to top of this page ***}} | {{actionlink>top|*** back to top of this page ***}} | ||
astra_conv/conversion/wiring/wiring.txt · Last modified: 2014/03/13 18:46 by richard
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
