This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
astra_conv:conversion:vacuum_pump:vacuum_pump [2013/09/13 12:48] admin |
astra_conv:conversion:vacuum_pump:vacuum_pump [2014/03/13 23:38] richard |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{indexmenu_n>015}} | ||
+ | |||
+ | ====== vacuum pump ====== | ||
+ | |||
+ | As already discussed [[astra_conv:conversion:conversion#substitute_for_all_engine_features|here]], an electrical vacuum pump is required to power the brake booster. | ||
+ | |||
+ | The pump is a used part, but in good condition. | ||
+ | |||
+ | {{:astra_conv:conversion:vacuum_pump:p1090114.jpg?600|}} | ||
+ | |||
+ | |||
+ | ==== circuitry ==== | ||
+ | |||
+ | The pump is controlled by a vacuum switch and the [[astra_conv:conversion:distribution_boxes:distribution_boxes#vacuum_pump_driver|vacuum pump driver]]. This is also shown in the general wiring diagram. | ||
+ | |||
+ | ==== mechanical setup ==== | ||
+ | |||
+ | The mounting bracket consists of a base that is bolted to the [[astra_conv:conversion:auxiliary_frame:auxiliary_frame#battery_box_frame|battery box auxiliary frame]], and a top part that holds the pump. | ||
+ | |||
+ | {{:astra_conv:conversion:vacuum_pump:p1090556.jpg?400|}} {{:astra_conv:conversion:vacuum_pump:p1090555.jpg?400|}} | ||
+ | {{:astra_conv:conversion:vacuum_pump:p1100424.jpg?400|}} {{:astra_conv:conversion:vacuum_pump:p1100426.jpg?400|}} | ||
+ | |||
+ | Mounted pump. It is essential to suspend the pump in very soft bearings. Otherwise, it will be terribly noisy. I have also put some butyl rubber dampening mats on pump and bracket to further silence it, and slightly throttled it's spin by a series resistor. | ||
+ | |||
+ | {{:astra_conv:conversion:vacuum_pump:p1100857.jpg?800|}} | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | {{actionlink>top|*** back to top of this page ***}} | ||