astra_conv:conversion:dcdc_converter:dcdc_converter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
astra_conv:conversion:dcdc_converter:dcdc_converter [2014/03/18 19:47] richard |
astra_conv:conversion:dcdc_converter:dcdc_converter [2014/06/20 12:53] richard |
||
|---|---|---|---|
| Line 24: | Line 24: | ||
| * On/off control input: If such an input were available, and if the "off" primary power drain were acceptable, one would not need a primary side driver or input relay. Even if the feature had it's price, it would probably pay if you consider your own effort realistically. | * On/off control input: If such an input were available, and if the "off" primary power drain were acceptable, one would not need a primary side driver or input relay. Even if the feature had it's price, it would probably pay if you consider your own effort realistically. | ||
| - | The implementation of a primary side driver (no control input available on the DC/DC converter) is described in [astra_conv:conversion:distribution_boxes:distribution_boxes#dc_dc_converter_primary_side_driver_and_output_relay]] | + | The implementation of a primary side driver (no control input available on the DC/DC converters that I used) is described below. |
| * Secondary idle reverse current: This is current that the unit will draw from the 12V grid when it is switched off. Two of the devices I have been testing had considerable idle reverse current of 60mA and even 200mA. This makes necessary an output side switch to isolate the device from the grid when idle. Unfortunately, it is not so easy to integrate a power FET here - it would be difficult to drive and would not cover all possible operative constellations. A relay, if driven without special precaution, tends to "stick" since the relay contact gets overloaded if closed too early. My solution is using a mechanical relay, but switching it on only when the output voltage of the converter has already approached the grid voltage. | * Secondary idle reverse current: This is current that the unit will draw from the 12V grid when it is switched off. Two of the devices I have been testing had considerable idle reverse current of 60mA and even 200mA. This makes necessary an output side switch to isolate the device from the grid when idle. Unfortunately, it is not so easy to integrate a power FET here - it would be difficult to drive and would not cover all possible operative constellations. A relay, if driven without special precaution, tends to "stick" since the relay contact gets overloaded if closed too early. My solution is using a mechanical relay, but switching it on only when the output voltage of the converter has already approached the grid voltage. | ||
| - | The implementation of an output relay with delayed switch-on is described in [[astra_conv:conversion:distribution_boxes:distribution_boxes#dc_dc_converter_output_relay]]. | + | The implementation of an output relay with delayed switch-on is described below. |
| - | Anyhow, a properly designed DC/DC converter should not require an output relay and thus save a lot of integration effort. | + | Anyhow, a properly designed DC/DC converter should not require an output relay at all and thus save a lot of integration effort. |
| * Overload behaviour: Best behaviour will be a simple U/I characteristics - so if the output current reaches its rated maximum, the output voltage will just dip a bit to prevent further increase of the current. | * Overload behaviour: Best behaviour will be a simple U/I characteristics - so if the output current reaches its rated maximum, the output voltage will just dip a bit to prevent further increase of the current. | ||
astra_conv/conversion/dcdc_converter/dcdc_converter.txt · Last modified: 2014/06/20 13:02 by richard
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
