This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
astra_conv:base_vehicle:restoration:gearbox_clutch [2014/04/22 10:59] richard |
astra_conv:base_vehicle:restoration:gearbox_clutch [2014/04/22 20:35] richard |
||
---|---|---|---|
Line 52: | Line 52: | ||
After taking the gearbox into operation again, it turned out that the radial clearance of the half-shaft bearings was too high. These bearings can be tightened by turning the toothed bearing ring, which is also visible on the two pictures above. A special tool is required to turn it. Since this tool was not available, I had to make my own one, out of an old bearing ring: | After taking the gearbox into operation again, it turned out that the radial clearance of the half-shaft bearings was too high. These bearings can be tightened by turning the toothed bearing ring, which is also visible on the two pictures above. A special tool is required to turn it. Since this tool was not available, I had to make my own one, out of an old bearing ring: | ||
- | {{:astra_conv:base_vehicle:p1110845_gearbox.jpg?370|}} | + | {{astra_conv:base_vehicle:p1110845_gearbox.jpg?600|}} |
- | {{:astra_conv:base_vehicle:p1110847_gearbox.jpg?370|}} | + | {{astra_conv:base_vehicle:p1110847_gearbox.jpg?600|}} |
{{actionlink>top|*** back to top of this page ***}} | {{actionlink>top|*** back to top of this page ***}} |